Pentamerous - Chopping Board

By Josh-Worley | Created May 25th, 2019 | Published May 25th, 2019

uploaded project image
project image thumbnail
project image thumbnail
project image thumbnail
project image thumbnail
A great intermediate project, the Pentamerous Chopping Board utilises an intricate mortise and tenon joint to connect four feet to the board. The project strikes the perfect balance between Origin and manual woodworking. Comprehensive making instructions are available to help guide you through the process.

2 hr

Intermediate

3

Category

Kitchen

NameSize
josh-worley_pentamerous_chopping-board_foot-top_step-1.svg
2 kB
josh-worley_pentamerous_chopping-board_foot-bottom_step-2.svg
867 B

- Solid Oak, Walnut, Cherry, Maple or Beech measuring approximately 360mm x 800mm. Thickness must be 18mm. - MDF board measuring approximately 300mm x 400mm. Thickness must be 18mm. - Dowel, 4 x 16mm lengths, 6mm Diameter.
- Shaper Origin - Dust Extractor - ShaperTape - 4mm T Handle Hex Wrench - 19mm Wrench - Double Sided Sticky Tape - 1/4" Upcut Router Bit - 1/8" Upcut Router Bit - Engraving Bit - Sharp 10mm Woodworking Chisel - Sandpaper (p80, p120, p180, p240, p360 grits) - Sanding Block - Non-Marking Clamps (X3) - Non-Marking Mallet - Lint Free Cloth - PVA Wood Glue

This project is licensed under the Creative Commons Attribution - NonCommerical - Share - Alike license