-Two 1/8" nyodynium magnets
-10mm Barrel Hinge
-Black Felt
-Wood of your choice, at least 3/4"
-Glue for magnets
-Shaper Origin
-Screwdriver
-Tablesaw or bandsaw
-Cut the Barrel joints to 12mm depth.
-Cut the magnet holes to 3mm depth (or depth of magnet).
-Cut bottom ring slot .6"
-Cut the top ring slot to .3"
-Cut the bottom profile to .75"
-Cut the top profile to .5"
-Cut out bottom portion using table saw or bandsaw if wood is thicker than depth needed.
-Cut out felt and fold to fit in slot.
-Glue Magnets in magnet holders.
-Slide barrel Hinges in slots and and tighten set screws.