Wavy Drawer Front Created by Will5 — Used this design on a hallway table drawer front because I had continuous grain around the entire apron and did not want to disrupt that by cutting out the drawer front with the bandsaw.
I would highly recommend using a 1/16th" diameter cutter because the 1/8th left too much of a gap. Do the initial 1 or two passes with the Origin then finish with a Scroll Saw or bandsaw.
Used this design on a hallway table drawer front because I had continuous grain around the entire apron and did not want to disrupt that by cutting out the drawer front with the bandsaw.
I would highly recommend using a 1/16th" diameter cutter because the 1/8th left too much of a gap. Do the initial 1 or two passes with the Origin then finish with a Scroll Saw or bandsaw.
Used this design on a hallway table drawer front because I had continuous grain around the entire apron and did not want to disrupt that by cutting out the drawer front with the bandsaw.
I would highly recommend using a 1/16th" diameter cutter because the 1/8th left too much of a gap. Do the initial 1 or two passes with the Origin then finish with a Scroll Saw or bandsaw.