Flush Ring Pull 1.5in

By Shaper | Created September 14th, 2018 | Published September 14th, 2018

uploaded project image
project image thumbnail
project image thumbnail
project image thumbnail
These are super quick and super easy to install. Im sure the hardware is available in a range of locations. but here is a quick amazon link: https://www.amazon.com/gp/product/B0046FMRH4

10 min

3

Category

Hardware Inserts

NameSize
Flush_Ring_Pull_1.5_v009.svg
11 kB

greater than 1/2" thick panel brass finger pull: https://www.amazon.com/gp/product/B0046FMRH4
Origin Small Phillips screwdriver
Obviously test cut this into a scrap piece of wood before launching into the finished door panel. 1: Take the stock 1/4" cutter, cut the two main profiles to the assigned depth. 2: Optionally change to a small 1/16" cutter and pilot drill the three screw holes to 1/4" deep

This project is licensed under the Creative Commons Attribution - NonCommerical - Share - Alike license