Shaper Origin
High grit sandpaper to get smooth edge on acrylic
Router/tempate bit
Cut acrylic to rough size
Engrave lettering in acrylic
Cut outer shaper of acrylic
sand outer edge of acrylic
Cut plywood/MDF template for outer perimeter of base
Cut 1/8 mdf to rough size
Cut bottom cover plate
Cut cherry to rough size
Cut cherry to final size with template bit and router
prepare to use SO on the top face of cherry
Create grid on cherry, place top designs by referencing bottom left corner
Route acrylic groove to fit, 0.25 deep. Note that if paper is still on acrylic a tight fit will become loose later
Route groove to fit for remote
prepare to use SO on bottom of cherry
Route patch for cover plate to fit
Route internal patch until the acrylic hole is reached
Route cableway