Keyhole Hanger

Created By Brock | September 14th, 2018

uploaded project image
project image thumbnail
project image thumbnail
Flush mount a keyhole hanger for a finishing touch to your project.

10 min

Easy

Category

Hardware Inserts

NameSize
OVAL PICTURE HANGING PLATE CUTOUT.svg
13 kB
IMG_20180913_200245.jpg
4 MB

1/4" or 1/8" up cut bit
This file should work well for the linked keyhole hangers, but may not work with other brands. Depths to cut the pockets are listed on the file. If you use a 1/4" bit the inner pocket will not be selectable as a pocket cut and must be cut using inside cuts only. There is a "T" shaped guide for help with visual placement. Simply align the top line with the edge of the workpiece and the vertical line with your placement mark. The "T" is exactly 2" wide and 2" tall and places the cutout 1/4" from the edge of the workpiece. There are also two 1/8" guide circles that can be used to locate pilot holes for the screws if desired.

This project is licensed under the Creative Commons Attribution - NonCommerical - Share - Alike license