Dog Bowl Stand
By Brett|BY-NC-SA 4.0 License|Created April 12th, 2019
Needed a dog bowl stand that was compatible with a ( trade-marked and therefore not mentioned ) bowl size.
40 min
Intermediate
59
Files included (3)
1' x 2' x 3/4" walnut for top
poplar for legs / rails
Shaper Origin
Standard router
Table saw
I used the shaper to completely cut out the top
I then glued up the legs and cut to size w/o taper
While still square, used the shaper to cut the tenons
Then, cut the taper on the legs and route the sliding dovetail
I need to work on my sliding dovetail skills.