Custom Tool Inserts Created by Bennet — My intent is to continue adding to this tool list as time allows.
I am not the best at editing SVG files; I tried to clean the files up the best I could. All files are solid and may easily be switched to outlines for easier layout.
Files are designed for an inside cut; a slight (-) offset of 1mm-2mm may be required for some tools to fit just right (dependent on the material you use - a snug fit in Kaizen/1.7LB PE Foam may be desirable).
My intent is to continue adding to this tool list as time allows.
I am not the best at editing SVG files; I tried to clean the files up the best I could. All files are solid and may easily be switched to outlines for easier layout.
Files are designed for an inside cut; a slight (-) offset of 1mm-2mm may be required for some tools to fit just right (dependent on the material you use - a snug fit in Kaizen/1.7LB PE Foam may be desirable).
Just a few choices to pick from
1.7LB Laminated Polyethylene Foam
4LB XLPE Foam
6LB XLPE Foam
1/4" Double Flute Straight Bit at a motor speed of 5-6
If cutting Kaizen/PE Foam, I recommend cutting to a depth where two layers of foam meet each other. Then manually remove the foam in the middle; you should end up with a fairly clean bottom surface.