Soss 100 Invisible Hinge

By Sam | Created February 28th, 2019 | Published February 28th, 2019

uploaded project image
project image thumbnail
project image thumbnail
project image thumbnail

10 min

Easy

0

Category

Hardware Inserts

NameSize
soss_100_v004.svg
10 kB

Origin Stock 1/4" cutter
Be sure to test cut first in inexpencive material to confirm you get the alignment and fit you want before performing the actual hardware installation. Use the grid feature to identify the side of the door you want the hinges on, centering the hinge on with the bottom center placement anchor is usually the best technique. The blue guides provide the recommended 3/32" offset from the edge. Cut large Pocket first. Cut smaller pocket second. Optional pilot holes centered on the guide circles. In softwood: #53 drill ( .0595" )

This project is licensed under the Creative Commons Attribution - NonCommerical - Share - Alike license